Thread: 4 link question
View Single Post
Old 06-23-2017, 01:01 PM
  #1  
mikeshemi
Junior Member
APPRENTICE
 
Join Date: Jan 2004
Location: mogadore,ohio
Posts: 18
Default 4 link question

I want to lower my top bars 1 hole. Problem is there isn't any holes left. My bottom bars are level.what would happen if i raised the bottom bar up 1 hole? In essence, would that have the same result as moving the top bars down? I can weld new tabs on to make the top bar lower 1 hole but was wondering if raising the bottom would do the same thing. Thanks
mikeshemi is offline