View Single Post
Old 05-10-2008, 07:36 PM
  #12  
jmarksdragster
Senior Member
RACING JUNKIE
 
jmarksdragster's Avatar
 
Join Date: Jul 2007
Location: Florida
Posts: 635
Default

First, NEVER run a solid trans mount. Chassis flex will usually break it when you start making power. Second, make sure you pull the driveshaft back at least one inch at rest (jacks under the rear end housing, suspension loaded) to engage in the rear end. Much less will jam it into the trans especially if, third, you run more than 4* down pinion angle, and you would need to fix as well. Fourth, your car needs at least a roll bar. I had a full frame Chevelle that ran 12's and was shocked at how much more consistent the car was after installing a roll bar.
jmarksdragster is offline