adjusting 4link woahs...
ok dumb question but i cant find the info anywhere... while adjusting the wheelbase on my car i find i must back the rod ends almost all the way out to get the wheelbase close to factory spec wich is 115" on all 55-57 chevy's i bought this chassis done already and got it cheaper than it would have cost me for the back half parts... figureing i'd have to do some work to it to get it right.... so here's my question what is the minimum thread engagement on a 4-link rod ends??? also the housing will not line up with the arch in the top of the framerails like the 4-link was from one supplier and the frame rails from another... man it probably would have been easier to just buy all the parts and start from scratch... well thanks for any help...