View Single Post
Old 09-15-2013, 03:27 PM
  #9  
Incognegro
Senior Member
DYNO TECH
 
Join Date: Jan 2009
Posts: 414
Default

I registered for that forum you suggested and am still awaiting an administrators approval.. Im curious to see what the issue might be with my set up.

I have since ordered the .250 spacer from lakewood and measured with the spacer. I get 2.637 from the spacer to the fingers of the pressure plate. My TO bearing to tranny is 2.600, so now I have a gap of .037 and the car will not go into gear, it is grinding like the clutch is not releasing. My TO bearing has a throw of between .43 and .688 depending on the stroke. My Master cylinder has a 1.1" stroke. so I should have around .50 of stroke.
Incognegro is offline