[quote="roadkill2"]Dunno. Were it mine, and it was doing the job, I wouldn't worry about it.quote]
x 2
It takes a lot of time to degree in a cam. Throw the biggest degree wheel you have on the crank hub. Now, measure the intake duration at zero, .050, (.100 and .200 if you are into lobe intensity) and full lift. Then you do the exaust side. Calculate centerlines and lobe separtaion angles. Throw a mock up head on these and measure push rod length.
OK we are thru, right? For 98% of us, that is it.
Think about this. We have only measured 12-1/2 percent of the available data.
Any one have a cammaster?