Originally Posted by Swiley383
I have what I need to start out loading but Iam having trouble getting the primers seated correctly. sounds like some of you have experience any advice? I have the manual and have done all adjustments for the primer seat just dose not seat far enough into the primer pocket.
Dunno about the equipment you're using so I can't give ya any suggestions.
FYI I use an old Lee Turret Press that I've had since back in the early 1980s and I've never had any issues with primers seating??
One thing to check on though is to make sure that there's no carbon build up in the primer pocket. They make a special brush to clean that area if the tumbler doesn't get it all out. Maybe someone else is familiar with that press setup and can offer some advice.