Harbone

I had an issue with the drivers side front turnsignal not working properly, turns out the socket was broke. So I ordered a new set.

I received the new front turn signals today, they are OER units and very well made











Remove the stainless trim off my old signals and polished them up





The one complaint I have with the new OER units is the stainless trim did not want to fit well through the curved part of the lamp. They seem to be molded a little wide in that area of the lens. I had to carefully take my Dremel and remove about 1/32" of an inch of the lens at that spot to get the trim to fit right.






The fit is real nice, I need to take the drivers side one back out and bend the mounting brackets just a tad to level it off in the opening