Harbone

Got the dyed upper and lower door panels installed Friday night. Used my original lowers, the uppers and new center inserts I bought on the net. Took a while to get the centers lined up properly and I ended adding an extra screw or two to make everything right but they look great!



Started putting the dash back together. Took my time and tried not to scratch anything. After some cussing and a few scratch's on my hands the dash is in. It did give me time to put a new wire in for the factory temp gauge. I also couldnt decide what to do about the sending unit for the oil psi gauge. After looking at the Sun oil psi gauge I realized I could take the braided line off the Sun gauge and the electric sending unit screwed right on it! Its too tight with my headers to install the sending unit on the block so now I am just going to make a bracket and install the sending unit under the dash and wire it into the gauge. Heres some pics of the refreshed and dyed dash installed.




Cluster is assembled with the oil psi gauge, I bought some LED'sfor the 6 illumination slots in the cluster and WOW, what a difference!




Finished up the lower dash and reinstalled my seat, not gonna recover those till late spring.