That's cool Zip... I wish they would let us run rollers in IMCA...?
BTW, how do you paste the pic on your replies? I wanted to copy and past my cam card but couldn't figure out how to do it...?
Yeah Stick, I guess it does not matter how good of oil you put in, if you got a bad grind and the lifters don't spin, it is only a matter of a couple minutes before it is total trash. And, hopefully the lifters don't mushroom so bad you have to take the entire engine apart and turn it upside down to beat them out from the bottom side. Been there done that a couple times... :evil:
Fortunatly, over the last 10 years I have only lost two cams that way... I guess I have been real lucky. I look at these cam kits on sale for $100 on eBay right now and just shutter thinking about the quality you get for a hundred bucks...?
Jim