ratfink1969

I'm looking for suggestions on compression ratio and cam selection. Ok, my goal for this project is to 11.40's-50's as cheap as possible with the parts I have laying aroud while I try to save money for a roadster. Would like to do this on pump gas if possible but it will be a strip only car so not needed. The car with driver should weigh about 3150 lbs give or take so I beileve I should need approx 360 rwhp or 450 flywheel. What I have availible 454 +0.030 stock rods, crank, stock 781 oval port heads. I also have kmotion k1000h valve springs and crane solid roller lifters and roller rockers, hooker super comp coversion headers, Holley 800dp the only intake for oval port heads that I have is an alluminum dual plane and may be willing to hunt another down but I do have a team g and strip dominator for rectagular ports. The car is an 85 camaro, caged and 2x3 subframe connectors, 9" ford and ladder bars, th350 with t-break, if that helps.

Thanks in advance Ryan