Hey hammer,
Elkyman here again and it's been awhile since the new info on your digger, very very nice setup and the numbers are looking real good so far. Shouldn't this engine make a few more ponies though for the cubes???? Seems like it would be in the 1000hp+ range real easy on motor alone, but then again, I don't know your cam specs either.....
Got my elky running finally and so far 10:13@ 134mph and the rear suspension is eating up the 9 sec. et as it spins a little off the line, more work is done to the rear susp. and now I have a elect. problem, hence this e-mail to you.
I need some help and info on what you used in your wiring setup and names and part #'s if possible and where you got your spools of wire from, heat shrink and connectors and eyelets and so on, my elky is getting a elect. makeover this winter as I keep running into elec. problems and it is making me sick of this pig, so before I sell it to the scrap yard, I want to run 9's with it first
I contacted Wires & Pliers and Michael helped me a bunch so far, but he is expensive but he does some of the best wiring around this state on drag cars, your 2nd to him
nice wiring also by you, you did a reat job of it all. So when you get this and read it, can you reply to
[email protected] for me? Then we can go from there. Thanks and keep up the great work, ps, don't sell it, make it work for
YOU Thanks hammertime.
Elkyman
John
NMCA Series