Search: Posts Made By: ChevyGuy327
Showing results 1 to 4 of 4
Search took 0.01 seconds.
Forum: Engine Tech
10-08-2007, 06:38 PM
Replies: 4
Views: 2,588
Posted By ChevyGuy327

Would it be possible to use a piston designed for...

Would it be possible to use a piston designed for a 5.7 inch rod / 3.48 inch stroke in place of a 6 inch rod / 3.25 in stroke?

I cant seem to find a chart that shows the varoius pin locations to...
Forum: Engine Tech
10-05-2007, 11:31 PM
Replies: 4
Views: 2,588
Posted By ChevyGuy327

327 pistons for 6 inch rods rare?

I have a small journal 327 im building and have the chance to aquire some nice aluminum rods for it (suposedly 6 inch) but when I search for a set of +.030 327 pistons for 6 inch rods I cannot seem...
Forum: Transmission
08-29-2007, 11:46 AM
Replies: 3
Views: 639
Posted By ChevyGuy327

Thanks for the info bill, Ill have to look at...

Thanks for the info bill, Ill have to look at some exploited views and see if I think I can handle it.

Most ive done as far as transmissions go was a valvebody shiftkit and a servo swap in a...
Forum: Transmission
08-29-2007, 10:43 AM
Replies: 3
Views: 639
Posted By ChevyGuy327

Is it possible to swap a 6" tailshaft with a 9" on

If so do I need to purchase anything?

I have a built to the gills 6" th-350

and an old worn out 9" th-350

Im replacing a 700r4 in a 1992 chevy caprice that will have near 600hp at the...
Showing results 1 to 4 of 4


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -