Search: Posts Made By: holeshotta
Showing results 1 to 17 of 17
Search took 0.01 seconds.
08-31-2014, 02:43 PM
Replies: 1
Views: 1,350
Posted By holeshotta

Looking for dragster set up help

Have a 235 swing arm. 34.5 x 17x16 good years and 4:30 gear. Motor is a 588 on alcohol with glide. 5700 converter and starting line enhancer. Questions I have

Tire pressure
Launch rpm
Shift...
04-06-2014, 09:53 AM
Replies: 4
Views: 1,574
Posted By holeshotta

ran fine the day before for 20 minutes idling...

ran fine the day before for 20 minutes idling getting ready, will check however, thanks!
04-05-2014, 01:19 PM
Replies: 4
Views: 1,574
Posted By holeshotta

Electrical help needed

i have a bb chevy dragster and went to track today and fuel pump fuse is blowing after ignition is turned on. Car sat all winter an neveran issue before. I have a painless 6 switch panel with fuses....
Forum: Help
11-03-2013, 06:57 AM
Replies: 4
Views: 4,362
Posted By holeshotta

Thx all. Tearing all down and looking today

Thx all. Tearing all down and looking today
Forum: Help
11-02-2013, 02:09 PM
Replies: 4
Views: 4,362
Posted By holeshotta

Help needed

My dragster starting acting very strange today. Would turn on fuel pump (fuse issue) then tach is bouncing all over throughout rpm range from idle on. It's a 582 with msd 7al3 and 16 volt system. ...
05-10-2010, 06:27 PM
Replies: 4
Views: 730
Posted By holeshotta

egt advice

thanks guys
05-10-2010, 03:54 AM
Replies: 4
Views: 730
Posted By holeshotta

Egt Range

lloking ofr some tuning advice. Have BBC 496 in dragster. normally race at 2500- 3000 ft corrected. 1050 Rupert Dom with belt drive and bypass. Have 170 jet on both sides. I have bought an EGT and...
05-09-2010, 05:38 PM
Replies: 3
Views: 1,060
Posted By holeshotta

dragster help needed

looking to keep consistent 60' and pick up a bit of ET. i am thinking of a looser converter as well. the tires are CO6 Hoosier. any thoughts on this range of 60 ft times? I ahve only made 60 passes...
05-08-2010, 06:21 PM
Replies: 3
Views: 1,060
Posted By holeshotta

hardtail help needed

Am running a 496 chevy in a 225 hardtail. Glide with 5600 stall 4.30 gear, new Hoosier 33.5X17X16. on poor tracks 60 ft is 1.17. went 1.14 today, ran 7.95 @ 166.78 on last pass. Running tires...
Forum: Transmission
02-21-2010, 08:42 AM
Replies: 9
Views: 8,930
Posted By holeshotta

What is everyone using for Powerglide fluid in dragsters

been hearing alot of different opinions out there. I have used the old Dex for many years but hearing alot more on hydralic fluids etc. Each opinions?
Forum: Engine Tech
07-11-2009, 04:56 PM
Replies: 7
Views: 857
Posted By holeshotta

oil

thanks all very much. May all your lights be green and win lights come on!
Forum: Engine Tech
07-11-2009, 02:12 PM
Replies: 7
Views: 857
Posted By holeshotta

question about oil for Alcohol BB Chevy

i am new to alcohol and hear alot of different opinions on oils and filters to use. I am running a 496 Chevy BB and alcohol Carb. Any thoughts or suggestions?
06-22-2009, 11:20 AM
Replies: 11
Views: 4,073
Posted By holeshotta

they are C07's........ before i buy new, I will...

they are C07's........ before i buy new, I will give less air a shot...... thanks
06-21-2009, 06:18 PM
Replies: 11
Views: 4,073
Posted By holeshotta

good point. I always try to repeat. i thank you...

good point. I always try to repeat. i thank you for the thought
06-21-2009, 12:34 PM
Replies: 11
Views: 4,073
Posted By holeshotta

dragster help requested

tires are a little over a year old. launching at 4200. stagging at 160 degrees.
06-21-2009, 11:50 AM
Replies: 11
Views: 4,073
Posted By holeshotta

dragster advice requested

i am new to dragsters coming over from fast 10.5 car. Bought hardtail racetech with 489 chevy on alcohol (1050 rupert) mechanical pump, merlin steel heads, eagle rods and pistons 12.5, 4.25 Callies...
06-21-2009, 11:33 AM
Replies: 3
Views: 1,081
Posted By holeshotta

dragster help

I am new to dragsters coming over from fast 10.5 car. Bought a hardtail racetech with 489 Chevy on alcohol (1050 rupert) mechanical fuel pump. Merlin steel heads. Eagle pistons, H beam rods, 4.25...
Showing results 1 to 17 of 17


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -