Racingjunk Forums

Racingjunk Forums (https://www.racingjunk.com/forums/index.php)
-   Transmission (https://www.racingjunk.com/forums/forumdisplay.php?f=14)
-   -   powerglide questions (https://www.racingjunk.com/forums/showthread.php?t=27385)

mtheulen 02-16-2010 06:15 PM

powerglide questions
 
Hello All:
Looking for some opinions from the powergide pro's. I was having issues with fluid leakage from the rear seal.When the boys rebuilt my glide they said the rear cover was tore up.
235 " rear engine dragster
hard tail
shortyglide w/brake
I did feel the car bounce going on the stop and also had issues with tire/spin tire/chatter from 330 on. ( off the stop)
Question
Did this issue occur from tire bounce/spin?
Do i have a alignment issue occuring?
Do i have no idea what i'am talking about! (best answer)
Any Opinions
Thanks Mike

hammertime 02-16-2010 07:50 PM

Mike is this a coupler or driveshaft ?
I've never seen bounce/spin cause a issue before, I've ran some crappy tracks with hardtails and never had a issue. Is it just leaking around the seal itself ?

shawnp 02-17-2010 02:39 AM

Mike

You very well could have early signs or alignment issues. I spent some time talking to Don Higgins from Crew Chief Pro. His car had a slight bend in the rear frame. This took the rear out of alignment and tore up a lot of things. I would check for square as a start. Will the bounce hurt it, not most likely the case but I would not rule it 100% out. Have you had your builder take a look to see if he can offer up some advice?

mtheulen 02-18-2010 07:34 PM

Guy's
Started to tke things apart and yes it is a alignment issue. Old Old hardtail car with coupler.I think also there may be a rail that bent. I will get it apart this weekend and resquare the motor/trans new mounts etc and keep saving for a new car in 2011.
Thanks all
Mike

Racefab57 02-19-2010 08:04 PM

If you replace the rear seal after alignment issues, replace the rear bushing also,(or is it roller) doubt it.DR.

mtheulen 02-21-2010 07:32 PM

Had to replace the rear cover, seal, bushing, so the boy's threw a kit in it also. hopefully i cured the alignment issue, will see what the next racing weekend brings
thanks
Mike

kwkracing 02-21-2010 09:52 PM

Does the coupler slide in and out of the yoke with no bind when the car is sitting on the rear wheels?

mtheulen 02-27-2010 06:02 PM

Sorry for the delay, been racing.
After i cut the mid mounts out and realigned ,yes i can slide the coupler.I was able to before, but i think i tweaked the rail. I have now reenforced it and so far (6 passes), everything is looking great! Now if i can just convince my wife i need a new car!
Mike

gnsrule 02-27-2010 06:32 PM

I see your from Arizona. Maybe its not necessaraly a new car you need, but a new track. :shock:

mtheulen 02-28-2010 04:45 PM

Oh No!
Any chance you were at the Firebird Div?
What a mess!


All times are GMT -8. The time now is 08:10 AM.