TH-400 HELP !!!!
Overhauled a B&M Racing TH-400, full manual, transbrake, reverse pattern.
I am missing the right possition of the ball that goes in the valve body (only one ball for this racing trans) Anyone that could help me find the right possition of that ball? Thanks, Oliver |
|
Originally Posted by jbsjunk
Can not send the tranny to a shop in USA as I am located in Panama, Central America. It would be cheaper to buy a new one than sending it to the states and back to Panama. Thanks, Oliver |
Geesh! Talk about customer support......... :evil:
I know there are a few good trans guys here, they'll show up soon enough. |
Originally Posted by jbsjunk
Geesh! Talk about customer support......... :evil:
I know there are a few good trans guys here, they'll show up soon enough. TKs Oliver |
You can try here http://www.yellowbullet.com/forum/forumdisplay.php?f=30
Hutch is a good man on trannys,one of the best in the country. I have also asked Hutch to join us,hope he does. Tom |
Re: TH-400 HELP !!!!
Originally Posted by CHEVYZ28
Overhauled a B&M Racing TH-400, full manual, transbrake, reverse pattern.
I am missing the right possition of the ball that goes in the valve body (only one ball for this racing trans) Anyone that could help me find the right possition of that ball? Thanks, Oliver Hope this helps, Hutch |
Thanks for stopping by Hutch and joining us here a RJ.
Lets all welcome Hutch,If you have any questions just ask Hutch,he's the man |
Howdy Hutch. Welcome aboard!
I gotta ask, do you know Starsky? :lol: |
Re: TH-400 HELP !!!!
Originally Posted by Hutchtrans
Originally Posted by CHEVYZ28
Overhauled a B&M Racing TH-400, full manual, transbrake, reverse pattern.
I am missing the right possition of the ball that goes in the valve body (only one ball for this racing trans) Anyone that could help me find the right possition of that ball? Thanks, Oliver Hope this helps, Hutch Regards, Oliver |
Originally Posted by jbsjunk
Howdy Hutch. Welcome aboard!
I gotta ask, do you know Starsky? :lol: |
LMFAO!!!!!
Bah ha ha ha...... :lol: :shock: |
I'm not going to say I know for sure where the ball goes. But in my expreience with this kind of problem, the best way to figure it out is clean the seperator plate clean and look across the surface for the hole that has a shiny bevel around it. To help farther, you only have six places that it sits in. Look for the hole that is shiny as the ball will rub it when it applies. That is the place it goes. Won't work with a factory plate as well due to all of them having shiny around them to some degree. Hope that helps.
|
LOL, just seen the date on this, I'm a little late.
|
All times are GMT -8. The time now is 05:18 PM. |