installing problem
hello! quick question, i am putting an older used tranny (350 turbo) in with a older 350sbc. the torq converter is tightened to the flywheel and its good, but when i snug the tranny to the block i can no longer turn it over. when there is about ia 16th'' gap it turns over fine with screw driver. thanks in advance!
|
any ideas?
any idea what is wrong?
|
Converter not seated in the pump is the likely cause. If you tightened the bellhousing bolts it probably broke the front pump in the trans
|
You need to rotate the convertor a few more time in the tranny pump with the tranny unbolted, The convertor is not all the way in the pump
|
Originally Posted by kwkracing
You need to rotate the convertor a few more time in the tranny pump with the tranny unbolted, The convertor is not all the way in the pump
|
When the converter is all the way on the shaft properly, spin it and you'll hear a clicking sound. That shows its engaged properly.
|
Originally Posted by chevyfireball
When the converter is all the way on the shaft properly, spin it and you'll hear a clicking sound. That shows its engaged properly.
|
X1,003,500,862,infinity X2 power.
|
All times are GMT -8. The time now is 07:14 AM. |