Procharger Motor build up Help
 

I want to build a Procharger motor, but this is for a 9.90/10.90 Car. .

I would like some input on the motor program.

I would like to build a 480-500 BBC
10-1 pistons
Alum Heads
Alcohol Mechanical Injection
20 psi Boost

I know that most of these motors are low compression gas carb or elec fuel injection.

Do I build the motor like our Blown SBC Top Dragster deal.
Alum Rods, 11.5-1 pistons
Or
Can I/Should I build it with good steel rods and a good crank

What do these guys with 565 BBC and 12-1500 HP have for internals?

If it were mine it would have at least 11.5 for compression and aluminum rods, but you could probably get by with steel rods at that power level