Engine came in
 

My new engine showed up Thursday. Mild 454 Dyno was 449hp 532ft/lbs.
Any volunteers for installation? :lol:
Now I just need a converter, rearend gears and all the little odds and ends.

HeHe, you trying to sucker somebody up to the cold country to help you install :lol:
Good luck, i can't even get help down here where it's warm :cry:

Zip.

I have a heated garage. :D

I already have a couple of guys lined up.
It's just finding the time to do it.

If you have room to place engine in car with tranny attached it will make life simple for you...this can be done normally with front clips off the car etc..
don't know how many motors/engine you have put in ...but a good cherry picker and a spotter..its not that bad of a job.....

It's going in an altered. So no front clip to worry about. :D
I'm no mechanic but my dad and brother are. My dad owns his own shop. So we will be using one of his bays.

been there Done that too...you will find this is a extra easy slam


[img]http://i210.photobucket.com/albums/b...n/altered2.jpg[/img]

how much beer do you got