Hardtail Altered Pinion Angle????
 

I am putting in a hardtail rear end in my 23 altered. Would you set the pinion angle at 0 or still set it down 1 or 2 degrees?

It needs to be set straight with the output of your transmission, plus or minus what the coupler allows as a tolerance.

Curtis

How would I know the tolerance? It is a powerglide trans with a 8 3/4 crysler rear end.

Is it a coupler or a driveshaft like mine?

Sorry I assumed it was a coupler and didn't even think of it possibly having a short drive shaft. You would have to check with the manufacturer of your coupler to see just how much misalignment it will stand. It won't be very much.

Curtis

It is a short drive shaft not a coupler. Should it still be straight on at 0?