guide plates
i just got my new pushrods but the problom is that i ordered 3/8 and my heads came with guide plates for 5/16 can i grind on these to open them up so my 3/8 pushrods go through them?or is that unsafe to do
|
G/Plates
My OPINION?
Just Purchase the CORRECT G/Plates! You have to remember,they are riding on the Push-Rods?If the motor was only turning a few Hiundred R's?You MIGHT be OK???? I would think 40.00 would Fix the Problem.........? Later G 8) |
All times are GMT -8. The time now is 04:03 PM. |