s10 tranny problems
I have a 88 chevy s-10 with a th350 a 350 engine and a 8.75 rear end since i have put the rear end in i have busted the bellhousing off 2 tranys and busted the bellhousing and tailshaft off 1.any suggestions?
|
What type of mounts are you using on motor? Trans? Solid mounts? Need more info on your current setup.
|
have heard people have this problem when they run a solid tranny mount, or only a front plate with no mid plate and solid tranny mount, or sometimes no mid plate and lots of hp
|
i have a front plate and a urathane trans mount
|
I don't think that's enough. Too much hanging weight between the two mounting spots. You need a midplate, but don't go solid on the trans. Big trouble there! JMO
|
ok thank you very much i give it a try
|
Did you do anything to the driveshaft when you swapped rear ends? If not, the driveshaft is too long...
|
Originally Posted by mytmouz
Did you do anything to the driveshaft when you swapped rear ends? If not, the driveshaft is too long...
|
we had to build a drive shaft it has i think like 3/4 of a inch play
|
Who did the work on the driveshaft and was it balanced?
|
All times are GMT -8. The time now is 12:37 AM. |