Racingjunk Forums

Racingjunk Forums (https://www.racingjunk.com/forums/index.php)
-   General Discussion (https://www.racingjunk.com/forums/forumdisplay.php?f=7)
-   -   9" sheet metal diff housing (https://www.racingjunk.com/forums/showthread.php?t=21591)

FAT622 08-10-2008 04:56 PM

9" sheet metal diff housing
 
Does anybody have some plans or photos of a sheet metal diff housing?

zipper06 08-10-2008 07:50 PM

This one was built for me by A.R.T, for about $1100.00, including all the bracing and 4 link mounts, also has big Ford bearing ends.
I primed it when i got it due too the humid conditions in La. in the winter time. Later it will be powder coated after i mount the wish bone and equalizer mounts.

Zip.

http://img28.picoodle.com/img/img28/...1m_d55816e.jpg

http://img32.picoodle.com/img/img32/...2m_2d28803.jpg

http://img33.picoodle.com/img/img33/...3m_39522ca.jpg

FAT622 08-15-2008 03:21 PM

Thanks zipper,

i found some good photo on some australian sites, Mcdonald bros racing and micks metal craft :D


All times are GMT -8. The time now is 03:39 PM.