Racingjunk Forums

Racingjunk Forums (https://www.racingjunk.com/forums/index.php)
-   Engine Tech (https://www.racingjunk.com/forums/forumdisplay.php?f=9)
-   -   bearing clearances bbc (https://www.racingjunk.com/forums/showthread.php?t=32626)

ejm 09-16-2012 07:19 AM

bearing clearances bbc
 
getting ready to put together 454 .040 over forged 4" crank factory rods (stess tested and ballanced) kb hyp 257 pistons 781's with 2.19 int valve bowl work and a .629 lift mech flat tappet wanting to know bearing clearance on mains and rods and endplay and if you could throw out some hp and tq numbers?

zipper06 09-16-2012 08:50 AM

If the crank measures standard, i almost alway buy .001 over bearing on both rods and mains, giving me .002/.0025 clearance, .022 side clearance.
I hope you put new good ARP bolts in the rods.

Zip.

ejm 09-16-2012 09:38 AM

yes they have arp rod bolts

ejm 09-19-2012 04:29 PM

what is the best way to set thrust bearings? have all toqed and loosen rear cap pry back and then forward with crank then torque?

zipper06 09-19-2012 07:12 PM


Originally Posted by ejm
what is the best way to set thrust bearings? have all toqed and loosen rear cap pry back and then forward with crank then torque?

Right on, pry forward last then torque.

Zip.


All times are GMT -8. The time now is 09:16 AM.