Holley 4150 HP idle air bleed change refresher course.
OK, need a refresher.
If I have throttle blades set with approx. .040" idle slot showing below blades, and my 4 corner idle screws give best idle at only 1/4 turn from full in, am I lean or rich? Will changing the air idle jet sizes allow adjustment to 1 1/2 turns out on screws and will this be any better idle quality than the 1/4 turm out? Bigger idle air jet will lean fuel/air mixture? What else is there to getting better idle quality? 377 SBC with .520 hydraulic roller cam, 750 HP carb, 21 degrees initial and 38 degrees total timing, 7-8" vacuum at idle, 1000 RPM idle in neutral, 800 RPM in gear, 3500 RPM converter. |
Rich, go the next drill size larger on the idle air bleeds.
|
All times are GMT -8. The time now is 04:53 PM. |