nitrous jet sizing
when chosing jet sizes for nitrous systems, should you go by the plate manufacturer or the solenoid manufacturer?
I have NX solenoids and an edlebrock plate, should I use the edelbrock jet map chart? |
I would use the solenoid manufacturers specs because its the solenoids that handle any potential flow. The plate will handle whatever jets you put in there.
|
Go by the plate the jets go in the plate and the plate does the mixing
Unless your solenoids are too small they will out flow the plate Solenoid = on/off jet = restriction/calibration plate= mixing/distribution of fuel |
Well, any other suggestions, lol
|
Normally I would say go with the plate, but Edelbrock's jet map is on the rich side by quite a bit. But there are other factors to consider as well.
Which NX nitrous side solenoid do you have? The 15100 is a small orifice solenoid which will make a difference in N2O jet sizing. |
All times are GMT -8. The time now is 03:38 AM. |