hammertime
03-15-2012, 05:31 AM
Went into the winter wanting to "beef" my engine, plans were jesel belt drive, better lifters, pushrods and a oil pan. I did swap oil pans (steel moroso to a steel moroso with a kickout)and took the timing chain off for a jesel belt drive, did a better lifter, but did not get to do pushrods (to much grinding while on engine). Decided late into doing the upgrades to do a intake swap, I've had a fall on its face issue anything past 7100 in the past and I had changed everything but intake. Here is the results
APD 598 short deck, bmf 385 heads same dyno and conditions, pretty fair A/B test.
Left side sheet is with a profiler sniper intake (fully ported)
Right side is the new sv565 with only a gasket match
http://i203.photobucket.com/albums/aa306/Dragster387b/598.jpg
APD 598 short deck, bmf 385 heads same dyno and conditions, pretty fair A/B test.
Left side sheet is with a profiler sniper intake (fully ported)
Right side is the new sv565 with only a gasket match
http://i203.photobucket.com/albums/aa306/Dragster387b/598.jpg