Blown BBC Head Gasket, ADVISE?

[bbchevy]

Heres the Deal?
427 T/Deck GM Block.
NO O-Ring Grooves,this Motor was in a Nost.Funny Car,and Ran Pretty GOOD!But,with Only 8-Passes on the Combo its a Hard Call?
Currently I have a set of Merlin 345 Iron Heads(VERY HEAVY)but a Good Head for a Blower Combo!
Heres My Delema?
This is going in my 95 S10 Back/Half Truck,standard Cab,so theres NO Room to Slide the Motor back!
I have a chance to pick up a Nice set of Edelbrock Chapman Heads (ALU)so that about a 150lb Swing.
The Motor had a set of Cometic Gaskets,that were sealing just FINE!
If I go with the Alu.Heads?
Will the Cometics be the Ticket?
OR?
O-Ring the Block and go COPPER?
Which is the Way I all my Old Motors were.But?That was before these Cometics were Invented?
Any Thoughts?
Thanks!
G 8)

[markdunlap]

Look into SCE titan head gaskets. Copper with seal ring made into them. No need for o ring groove and have silicone beading around water holes.

[zipper06]

Look into SCE titan head gaskets. Copper with seal ring made into them. No need for o ring groove and have silicone beading around water holes.

X2, i use them.

Zip.

[bbchevy]

So,My take so far is go with the SCE Copper Gaskets over the Cometics,with Aluminum Heads.
THANKS fo the Input,Fellows!
Later
G 8)

[markdunlap]

I did not mean to down grade the Cometic gaskets. In fact I ordered a set today. I was just trying to offer an alternative to having to o ring the block.

The Cometics do require a very precise, fine finish deck surface on the heads and block to work. They do work fine if that is done.

[hammertime]

cometics here been fine for 4 re-uses :)