ZEX Perimter Plate system

[Robsinno]

I like the idea and design of this nitrous plate system. Does anyone have any experience with these or know of someone that does?

http://www.zex.com/Pages/82/Carb-Perimeter%20Plate.aspx

Thanks

[cs]

its a great kit
we had it on sbc and did what we wanted with no problems

we also have the kit for sale as we went to bbc

[MillerTime12]

Got it on my car now, i love it. I got the kit that adjusts form 100 to 300 hp fromm summit for less than $600
Great set up

[coloradoracerguy]

Not to hijack this thread, but does anybody know how it would work with a cloverleaf style intake, 4500 flange?

Thanks

[cepx111]

Not to hijack this thread, but does anybody know how it would work with a cloverleaf style intake, 4500 flange?

Thanks

Good question.

I suppose it would not work as them plates are pretty square, maybe on top of a open spacer?

Dam it Jim, back to the drawing board...



Cp

[zipper06]

We put a XEX on the 468" 3700lb Biscyne with a 2" spacer. At first we had it installed on top of the spacer and it performed like crap. We were then told to install it below the spacer, the car picked up 3 tenths, i think it might be the same with a cloverleaf manifold, but i'm only guessing. Now this car weighs 3700 lbs plus without driver and it runs 6.20's in the 1/8 mi. Don't know what it will run in the qtr. since the change but it ran 10.31 before the change.

Zip.