View Full Version : ROCKERS CAME APART, NEEDLE BEARINGS IN OIL PAN
motorobb625
03-09-2009, 05:34 PM
I just bought this 427 small block that had 2 rockers broken off at the mount. (one of the rockers spilled all its needle bearings) most of them were laying on the head. I pulled the oil pan and did find a few in there along with some brass shavings. the motor runs great but is it safe to keep it going with out a complete tear down ?
hammertime
03-09-2009, 05:53 PM
I just bought this 427 small block that had 2 rockers broken off at the mount. (one of the rockers spilled all its needle bearings) most of them were laying on the head. I pulled the oil pan and did find a few in there along with some brass shavings. the motor runs great but is it safe to keep it going with out a complete tear down ?
No way would I not pull it apart
TheYellaBrick
03-09-2009, 06:29 PM
Metal shavings in oil pan equal shavings EVERYwhere.....Rip 'er apart....If everything looks good including the bearings, clean VERY well including a block dunk and screw it back together. These little things happen for a reason...you'll probably find something within that would have caused catastrophic engine failure anyway. At the very least you'll know EXACTLY what you have ! :D
I972Nova
03-09-2009, 07:08 PM
Yep it sucks but you HAVE to pull it apart and make sure everything is ok. Throwin a new set of bearings and new gaskets is alot cheaper than tearing stuff up.
cepx111
03-09-2009, 10:14 PM
Where did the brass come from?
zipper06
03-10-2009, 04:09 PM
Where did the brass come from?
X2,
it might be from the distributor gear, but i would want to know for sure, pull it apart.
JMO
Zip.
blowenstang
03-10-2009, 07:25 PM
rip it apart to be safe
brass could of came from a seat or it might came from the
bushing around the wrist pin
blowenstang
03-10-2009, 07:26 PM
come on cep your a race master
radicalz
03-12-2009, 01:34 PM
I would not guess at what it went thru I'd be tearing it down to make sure ewverything is ok.... :wink: :wink:
motorobb625
03-15-2009, 03:57 PM
you guys were right ,I tore down the motor this weekend and discovered serious main bearing damage. Any idea what a machine shop will charge to dip the block, intsall cam bearings, and disassemble / and clean heads for? I have never done any thing this major to a motor before. Thanks for all your help!
bjuice
03-20-2009, 05:30 PM
I think the correct answer for you here is ask for some reputable machine shops in your area the call them up and ask what they charge....but on the flip side no one can price something on the phone...just No way of knowing what needs to be fixed..
Another side (IMO) i just don't feel its appropriate to start trying to price anothers work.
besides anyone on here could only guess..cause we have no way of knowing the extent of your damage..so to put a number in your head would not be fair to you or the machine shop you may seek to hire for the job.
this is just My opinion. of course.....where do you live ?..lets see who's close to you some of us May know..if you in S.C. i can help you a ton with reputable guys. :D