Strange strut lower control arm brackets

[prhjf]

How do you position the strange strut front lower control arm bracket and the rear lower control arm bracket onto the chassis?
Is there a jig fixture that is available other then the Chassis Engineering type?

[zipper06]

Are you talking round tube chassis or rectangular tube chassis. I think i have the diminsions for a rectangular tube chassis.

Zip.

[prhjf]

Can you send me the info?

Thanks

[promod45]

first of all i need to know do you have some kind of strut fixture to hold strut at the right degs and level if not. you need to stop right there as you are already wrong in what you are doing. This process of setting struts up over the e-mail is alot of typing, so one step at a time

[zipper06]

first of all i need to know do you have some kind of strut fixture to hold strut at the right degs and level if not. you need to stop right there as you are already wrong in what you are doing. This process of setting struts up over the e-mail is alot of typing, so one step at a time

You are absolutey right it's just not easy to setup struts. I have already sent him imfo on this project, but that doesn't mean it will work for him. This chassis 96" has already been delivered and runs near 150 mph 1/4. but it doesn't mean it will work for him because his chassis is different. I hope you can help him because i have limited experience.

Zip.

http://img248.imagevenue.com/loc189/th_53410_vega_strut_122_189lo.jpg (http://img248.imagevenue.com/img.php?image=53410_vega_strut_122_189lo.jpg)