first big block

[ncoffroader]

:oops: i just bought my first bbc(454) and have no clue what is what,square/round port is this intake or exhaust?are big and small block dist. the same?tranny bolt pattern same?any help would be greatful thans

[lanham]

Transmission bolt pattern is the same as a sbc.Distributor is the same.Rectangle port and oval port refers to the intake runners.

[ncoffroader]

thanx now time to buy some parts

[cepx111]

Welcome to the land of woo..

Goodluck, Charles

[Tod74]

Welcome to the land of goofy valve train :lol:

[ncoffroader]

ok now i have some basics can somebody tell me what i have and is it worth going thru? on back of block it has the number 364779 cast into it,thanx ahead of time for the help

[superstreet2055]

all of the casting number codes you're looking for can be found at www.mortec.com.

[ncoffroader]

i looked up the casting number and it says its a "366T" so that means i have a bbc with small block displacement?what a piece of crap! :x so what do i do junk and start over or is it worth fixing?

[sc3314]

all depends on what you are looking to do with it? What you have is a standard truck motor.

[ncoffroader]

my plans were to put it in my suburban,i am running 46" tires so i was looking for alot of torque

[Tod74]

I thought the 366 truck motors were different than the reg mark iv bbc...but i don't know.

[russ67chevelle]

you have a 4 bolt main capped motor.i dont know how big you can bore your motor out to,but ive heard that the old 366 and 427 truck blocks can get up to 4.375" SOMETIMES.i would sonic test it after it gets opened up to common 454 size of 4.250".it is not a total loss for all that youd have to do is pay a little more for a bore job.