It has 22 1/2 inches at the shoulders and 36 inches seat to roll bar.Above Added: Tue April 19, 2022, 4:02 pm ESTIt has a 22.5 inch cage. I am 6 foot and 230 lbs and Iti fits greatAbove Added: Tue April 19, 2022, 8:29 am ESTThis is definitely an example the ultimate Top Dragster. This is a newly assembled Spitzer 285 inch Top Dragster with only the best parts. The engine is a Phillip Oakley 540 Brodix aluminum block and heads that have all received HIP processing. There is a Procharger F3 charger on the engine. The engine was tested in a shorter dragster and went 4.0 at 187. Then it was installed in this car and has not been run yet.
The transmission is a reid case with all Sonnax internals with a large shaft, 1.59 gear set and Sonnax 10 clutch set. it is attached with a new Abbruzi torque convertor.
The rear end is a sheet metal housing with Mark Williams aluminum axle housings, full floater axles and carbon fiber brakes.
There are two orange chutes, a racepak 300 with every sensor that could be needed and it is hooked to an MSD grid that is all set up.
The seat is upholstered in pleated black vinyl.
I designed this car to be driven to and from the pits and the run. It has a radiator and fan that are controlled automatically and a transmission cooler and fan that are also electronically controlled..
I cannot run this car so I am giving someone the opportunity to have a great car that is ready to go and easy to run. If you are ready to go racing just call Chuck at 330-352-8908