Filter By:

Rolling chassis Massey 44 rear end No time to pull like I thought I would have My loss your gain 513-305-3550
Posted on 11/30/2017

Russellville, OH

I have a Profab 3 speed Trans with Rev. Input and output are 1.75-10 call for more infor 412 - six eight zero 1889 Thanks,
Posted on 11/27/2017

Clinton, PA

I have a good condition SCS-30 series gear box. Output is 1.75-10. Input shaft is 1.375-10 but you can get just about anything from SCS direct. This.....
Posted on 11/27/2017

Clinton, PA

Dana 60 hubs with 35 spline drive pucks. Also have the caps and springs for the knuckles. 
Posted on 11/26/2017

Scottsville, KY

Aluminum wedge chassis, 106 rearend with aluminum carrier and front section, ITPA approved  rollcage , new front wheels and tires, Real Wheels with.....
Posted on 11/24/2017

Washington, MO

Up for sale is a clean Low Miles Sport Chassis Ranch Hauler. This Freightliner comes equipped with the Cummins ISC 330.....
Posted 2 months ago

Wexford, PA

This unit was bought new and has 4 pulls on it!! Perfect condition. Complete kit sells with 1450 yokes and spare gear sets. Cash only no trades Also.....
Posted 2 months ago

Waukon, IA

New, almost completed
New chassis, NTPA certified roll cage, set up for 1 or 2 chevy or hemi.....
Posted 2 months ago

Stedman, NC

Banter twin engine unboltable stack box. Gears and shafts have been magnafluxed w/ no cracks.Comes with (2) 1 5/8"-16 spline cplrs. $2000 Kent Urban.....
Posted 2 months ago

Osceola, NE

For sale, Complete Chromoly roller, less motor and trans, set up for SBC and th400, real wheels with new fully cut Cepek's in 2017 ( only 7 pulls on.....
Posted 2 months ago

Rockwood, ON

Go to Page:

Copyright © 2005-2018 All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy

Execution Stats: 0.140 sec / 8.5 MB used / 8.7 MB peak