Husky Camper Jack - HT87247
Powered jack features a ball-bearing screw system that reduces noise and wear and operates more efficiently than standard screw systems. Automatic stop prevents damage to gears. Front and side LEDs offer nighttime visibility.
Electric jack with powered drive lets you lift and lower your trailer quickly and easily
Low-friction ball screw minimizes resistance to reduce wear, noise and heat
Ball bearings roll smoothly through threads - no direct, friction-inducing contact
30 Percent less power draw than typical screw systems
Automatic stop prevents damage caused by hard stops and excessive pressure
Motor is shut down before nut reaches end of shaft
3 Built-in LEDs illuminate area to front and sides of jack for superior nighttime visibility
Side lights ease weight-distribution hookup and disconnect
Trailer connector storage bracket guards trailer wiring from the elements
Drop leg allows for greater adjustability
Large footplate provides excellent stability
Hardened steel gears and stainless steel fasteners offer maximum durability
Sturdy cover and weather-guarded switches prevent water-related damage to motor
Silver powder coat finish resists corrosion
Bolt-on installation for A-frame trailers
Manual override crank, 6' of 10-gauge power supply wire, and 30-amp fuse included
Total travel: 24"
Drop leg: 6"
Lift capacity: 4,500 lbs
Tubing diameter: 2-1/4"
Footplate diameter: 5-1/2"
10" Travel in 38 seconds
25-Amp draw at rated load
Smooth, Low-Friction Operation
Typical jack screw systems feature direct contact between the surfaces of the screw and the threaded nut. This constant contact produces a good deal of friction, which not only increases the amount of power necessary to operate the jack but also creates heat within the system. Heat leads to increased wear on the threads, and this wear can ultimately lead to failure.