Fabricated 9" G body car - $880

WWW.TRICKCHASSIS.COM

Listed By Trick Chassis
Contact (608) 313-9197
Fabricated 9" G body car   for Sale $880
$880
Business Seller - Trick Chassis
Beloit, WI
RacingJunk Classifieds Message Seller
Report This Ad

Item Details

Ad Number184031314
ApplicationDrag Racing
ConditionUsed

Description

Trick Chassis 9″ Rear axle for 1978 to 1988 G Body cars



Below is what comes with it for $880:

Brand new center fabricated housing can (STANDARD) Others charge $100 more

Internal axle tube gussets (STANDARD) Others charge $75 more

3″ .250 wall DOM axle tubes (STANDARD) Others charge $30 more

4 lower control arm mounting holes (STANDARD)

28, 31, 35 spline axle options (YOUR CHOICE)

Drive studs included 12mm, 1/2-2″,1/2-3″ (YOUR CHOICE)

Housing vent included

wheel bearings included

Shipped bare steel

We can narrow for free (see options)

Options for additional charge:

T bolt brake hardware kit (easy install of your stock F body backing plates)

40 spline upgraded axles (gun drilled)

5/8 wheel studs

11 Hole narrowed lower brackets

Powder coat

Tow Loops

Fill and drain caps

Coil over brackets

Coil over brackets with no spring perches added

Please call or email us for pricing and estimated time:

We offer full bolt in assemblies

Extreme custom applications (we have done many of these)

Crate and freight available

International shipping* Our website will not calculate dutys/taxes/shipping/broker setups.

Important information:

When selection “differential options” This is telling us what center section that you already have, or are planning on using. The axle lengths will be cut accordingly. If you purchase this for a spool then later down the road want a clutch lock or S-trac or True Track ect ect. One axle may not fit and will need to be trimmed down. Or if you bought this for anything but a spool, and then use a spool center section, the axle could end up being too short on one side. You will not have enough spline engagement.

Axles are shipped with no bearings on them. Your stock backing plate needs to go on first then the bearings get pressed on behind them.

Axles are dropped shipped and may show up at an earlier or later time than the housing.

Payment Details

TradesNot Accepted

Message Seller

Send Message



I agree to receive emails from RacingJunk.com . I understand that I can unsubscribe at any time.
Privacy Policy

About The Seller

BUSINESS SELLER
Trick Chassis
Member Since June 2006
CONTACT INFORMATION
13437 W State Rt 81
Brodhead, WI 53520
(608) 313-9197
(608) 313-9197
Get Transportation Rates

Location

View All Resources

Buyer Resources

More From This Seller

Similar Classifieds
Copyright © 2005-2020 MH Sub I, LLC dba Internet Brands All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the RacingJunk.com
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy
Do Not Sell My Personal Information

Internet Brands