General Motors 1968 - 1972 A Body New Flanged Housing 62.5" Stock pinion Location with Big Ford Housing Ends.
Wheel mounting flange to wheel mounting flange will be 62.5" with brakes and axles installed.
1968-1972 Chevelle, Cutlass, Regal, Lemans, GTO, etc.
Stock rear end pinion yoke location between wheel flanges when center section is installed. This means standard driveshaft location to the passenger side exactly like a General Motors rear.
New Stamped Housing with new 3" x .188" wall DOM tubes.
CHOOSE Big Ford Housing Ends; New Style (torino) with .375" (3/8") bolt holes OR Big Ford Old Style ends .500" (1/2")
CHOOSE Fill and drain plugs; None OR 1/2 npt if requested when you order.
SPECIFY if you are running drum or disc brakes (brakes not included)
SPECIFY 2 3/8" or 2 1/2" axle offset for brakes
Flanged 31 spline axle axles have 3.15" tapered A20set bearings installed.
Axles are cut to length to match the housing
CHOOSE Axles have three bolt patterns in all axles, 5 x 4.5" small ford, 5 x 4.75" GM and 5 x 5". Choose which pattern you want the wheel studs installed.
CHOOSE 1/2" press in wheel studs; short for custom wheels OR Moroso Long for Racing. (we do not offer 7/16" studs as they will not fit our axles and are unsafe with a higher HP vehicle).
4 bolt axle retainers included to match your housing.
T-bolts kits included to match your housing ends.
You must send us a message with all the CHOOSE & SPECIFY answers before we can start building your housing axle kit.
Please call Brock with any questions 636.629.6200 or email him at [email protected]