04 Mustang Mach 1 Twin Turbo - $31,900

Listed By lyonsdc
Contact (330) 559-6552
04 Mustang Mach 1 Twin Turbo 04 Mustang Mach 1 Twin Turbo 04 Mustang Mach 1 Twin Turbo 04 Mustang Mach 1 Twin Turbo 04 Mustang Mach 1 Twin Turbo 04 Mustang Mach 1 Twin Turbo 04 Mustang Mach 1 Twin Turbo 04 Mustang Mach 1 Twin Turbo 04 Mustang Mach 1 Twin Turbo 04 Mustang Mach 1 Twin Turbo 04 Mustang Mach 1 Twin Turbo 04 Mustang Mach 1 Twin Turbo 04 Mustang Mach 1 Twin Turbo 04 Mustang Mach 1 Twin Turbo 04 Mustang Mach 1 Twin Turbo 04 Mustang Mach 1 Twin Turbo 04 Mustang Mach 1 Twin Turbo 04 Mustang Mach 1 Twin Turbo 04 Mustang Mach 1 Twin Turbo 04 Mustang Mach 1 Twin Turbo 04 Mustang Mach 1 Twin Turbo 04 Mustang Mach 1 Twin Turbo 04 Mustang Mach 1 Twin Turbo
$31,900
Private Seller - lyonsdc
Boardman, OH
Message Seller
+ Add to Favorites
Report This Ad

Item Details

Ad Number183106149
ConditionUsed

Updates From Seller

UPDATE: We got to make one final track outting before winter. Got the exhaust leaks fixed but did not get the new boost controller in. Made a go of figuring out the MSD and ended up re-wiring it to get it to work. Managed a [email protected] pedaling most of the front half of the track and running 40 mph out the back. Over the winter I am going to clean up some of the wiring put the new boost controller in and get ready for spring.

We also mounted a new alternator cut off relay so the switch now works when the car is running. I also have the NHRA chassis inspector coming to re-cert the cage.

New owner can be running mid 8's in the spring time!! Above Added: Sun November 4, 2018, 4:06 pm PST

Update: I have been sorting out the car with the new motor with some street miles and a trip to the track. Only made a few test passes with the car nothing exciting. Car goes straight no fluid leaks or issues. It has developed an exhaust leak which hurt ET but will be fixed this week. Car ran 140 mph on only 17 psi of boost!! This is at least a mid 9 sec pass on a very mold street tune! The car will go mid 8's!.

I am also going to replace the MSD boost controller with a new Boost leash with bump box. I am also getting belts cage and window net re-certified. I plan to have the car out again in early spring. No change in price with new upgrades. Above Added: Fri October 26, 2018, 5:34 am PST

Description

2004 Mach 1 Twin Turbo 1400 HP

This is a no expense spared build that was done professionally This car is 100% street legal and was street driven regularly and has competed in NMRA True Street class. The car is legal for NHRA drag racing to 8.50. The current spec on cage, belts and window net have expired since car has not been on the street or raced in the last 5 years. The motor and trans are BRAND NEW with less than 20 miles on them.

The previous motor had gone low 9’s at over 160mph and made over 1100 rwhp on a Dynojet chassis dyno. This motor should make much more. We recently fired the motor did all basic maintenance and the car runs good and make good boost on the street and is very street friendly.

Below are the basics I could not even begin to list all the modifications and upgrades done to this car.

2004 Mach 1 40th Anniversary 24k miles zero rust accidents or issues this is a single owner car and all modifications were done by the original owner. Body and paint are custom and 9.5 out of 10 with custom air brush graphics this is not a wrap.

4.6 Mod Motor with custom ported 5.4 head by MMR with complete valvetrain and custom Bullet cams specific for turbo combination. Brand new block and crank with custom extreme duty Manly rods and pistons.

Custom billet sheetmetal intake manifold with Accufab throttle body.

Twin billet wheel 6262 Precision Turbos with recent refresh with Tial 46mm wastegates with custom air to air FMIC

Custom SS twin turbo headers downpipes and exhaust system

BigStuff 3 Fuel Mgt with LS CNP system Racepak dash with DAE logging and LS style coil on plug conversion. MSD launch control boost controller

Abbruzzi Racing TH400 with billet alum fwd drum input shaft JW Bellhousing, trans blanket.

PTC 19 blade Torque Converter

8.8 Ford rear end 3:50 gears 35 spline axles spool with 9” Ford housing ends and rearend brace QA1 coilvoers

BMR rear suspension with Adj UCA LCA and suspension bracket and UCA mounts.

QA1 front tubular crossmember with QA1 upper and lower control arms

ProEFI 750 Fuel pump custom aluminum gas tank -10 feed -8 return. 120# injectors with Weldon fuel pressure regulator.


This is an 8 second street car that can be driven anywhere.

Payment Details

TradesAccepted
Accepted Payment Methods Cash

Message Seller

Send Message

About The Seller

PRIVATE SELLER
lyonsdc
Member Since March 2005
CONTACT INFORMATION
Boardman, OH 44512
(330) 559-6552
Honor Payments
Lifetime: 0
Last 12 months: 0 Learn More
No Achievements Yet
Bronze Seller Silver Seller Gold Seller Platinum Seller Power Seller
Get Transportation Rates

Location

BOARDMAN,OH
View All Resources

Buyer Resources

Insurance
Shipping
Similar Classifieds
Copyright © 2005-2018 MH Sub I, LLC dba Internet Brands All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the RacingJunk.com
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy