For sale is a used Edelbrock Small Block Mopar dual quad intake manifold. It is in nice used shape and comes with the hardware to seal the top and a new top gasket. I bought this manifold to use on a small block build I was doing but have since sold the car so this intake and some other parts I have are being listed for sale. The thermostat mounting pad and the side of the intake flanges that seat against the cylinder head have no pitting. The carb mounting pads and the thermostat housing mounting pads have no stripped threads. I ran a tap through them all and they are fine. The intake ports appear to be stock and have no porting. The intake was painted silver at one point. It looks very nice as you can see in the picture.
There are a couple of items I will point out. First the intake top had been damaged at one point and well repaired. See underside picture. It is very hard to notice the repair from the top as you can see in the pictures. It will likely not be possible to see once the carbs and linkage are mounted. Second, the base mounting holes for the top plate have Heli coils. Third a few of the top mounting holes have been open up slightly to facilitate mounting the top I would suspect. Fourth there is an extra hole drilled into the top for an additional vacuum fitting – see brass fitting on the picture of the top. Also one of the thermostat accessory holes has a very small piece missing.
This is a nice intake and hard to find. I do not have the linkage but have seen them is available here on eBay as well as replacement top gaskets.
Price is $2250 shipped to the lower 48 states. I will ship internationally for the additional cost.
I can only post one picture so contact me for more pictures and information