This is an RME 1000 cylinder head holding and leveling fixture with an intake manifold mounted on it. This is the same fixture that we use to resurface cylinder heads except it has an extra jack stand.
This is a NEW complete cylinder head mounting and leveling fixture for surfacing cylinder heads and intake manifolds on a resurfacing machine
There is an eccentric cam on the head plate to adjust the X axis and an adjustable work support stand to adjust the Y axis.
You can install and level a cylinder head in five minutes.
The roll over bar is a precision 2″ bar. With additional tooling you can use this bar to surface engine blocks. You can use BHJ type main bearing housing bore rings if you want to but they are not required.
An adjustable work support assembly is included.
This is a very heavy duty holding fixture. A ridged fixture is very important in achieving the desired surface finish.
The precision ground V-blocks are 6″ X 2.5″ and the hold down bar is 1″ x 2″ x 7.5″.
The precision ground V-blocks locate on the parallel risers on your machine. The parallel risers are not included.
The bar is made from high carbon steel that has been turned ground and polished. It is a precision 2″ diameter bar. It is 40″ long.
The head mounting plate is made from very high quality aluminum and it was machined on a HAAS CNC machining center right here in the United States of America.
The head plate dimensions are 26″ X 6″ X .750″.
All the studs, flange nuts and t-slot nuts are included.
The price for the complete head holding and leveling fixture is $1200.00
I will refund the purchase price and pay for all the shipping if the buyer is not satisfied.
Crating and shipping cost a flat $95.00 anywhere in the lower 48 States.
We ship world wide.
Call me at 828-208-6000 for an international shipping quote or if you have any questions.