MD-250 – A perfect combo of exceptional value and performance
This is a custom portable unit that you can take on the road with you. Custom aluminum ramp system. Special 4 caster wheel kit to move it around then lower in place.
For the fully equipped shop, no dyno offers more value or better in-house motor vehicle testing capabilities than the Mustang MD-250. For starters, the MD-250 can boasts a 1,300 horsepower measurement capacity at a top speed of 175 mph and a powerful air-cooled eddy current brake provides the MD-250 with 900-hp worth of loading capacity. Do not be fooled by its compact size – the MD-250 is a serious dynamometer with serious tuning capabilities.
The MD-250 uses its powerful eddy current power absorber, a frictionless, air-cooled braking device, to enable it to apply variable and steady state loading. A complete control and data acquisition system lets you design a wide range of tests or select from a host of pre-configured tests included with the standard system.
The 250’s traditional four roller design makes setting up vehicles a snap – simply drive onto the 250 and let your tires settle in between the rollers. The 250 can be installed above-ground or below-ground, it’s your choice. The above-ground system utilizes an optional premium platform and ramp system with an above-ground restraint kit. The addition of an axle pull down kit help keep the tires from slipping or trying to “climb out” of the rollers.
Max Horsepower: 1,300 hp
Max Absorption: 900 hp
Loading Device: Air-cooled eddy current power absorber (model MDK-250)
Torque Measurement Device: Strain Gauge Type Dynamic Load Cell. Provides closed loop control signal for dynamic vehicle loading.
Inertia: Approximately 2,000 lbs. base mechanical inertia
Max Speed: 175 mph
Controls: Closed Loop Digital Controller with Windows based PowerDyne Software. Includes Patented Virtual Road Simulation Technology.
Precision machined and dynamically balanced
Knurled finish for superior tire traction
Belted for bi-directional capability
10.7” (272mm) diameter balanced rolls
40” (1,016mm) face length
28” (711mm) inner track width
108” (2,743mm) outer track width
19.6” (498mm) roll spacing
Roll Lock: Industrial brake pad in contact with O.D. of roll
Roll Decelerator: Allows vehicle deceleration without use of vehicle brakes. Eddy Current PAU used to decelerate rollers.
Air Requirements: 100 PSI, dry, regulated, oil free
115 VAC, single phase, 60 Hz, 15 Amps (computer)
230 VAC, single phase, 60 Hz, 40 Amps (dynamometer)
Axle Weight: 12,000 lbs (2,727 kg) maximum
Shipping Weight: 4,500 lbs. (dynamometer weight only)