Front and back halved in 2011. Less than 150 1/8 mile runs. Also included set of pro jacks, transmission cooler. May separate Hemi, Bruno/Lenco, DMPE M5 Blower and Hat. Above Added: Wed April 24, 2019, 6:13 pm PST
Shoulder hoop is 20.5 inches. Cage was updated and opened up when back half was done.
Items that come with car.
Spare 11 inch billet converter
A B and AB billet stators from Mick Snyder.
Bruno drive was updated by Brad Tuttrow with low voltage selonoid and flowed.
Lenco is a CS2 two speed with a three speed case with gear set eliminater 1.48 low gear
M5 DMPE blower with flowed three hole injector hat by DMPE also done with set back plate. Restripped and services two runs ago
Gorr adjustable barrel valve
Engine is a billet TFX block purchased new. Never damaged 4.375 bore 3 inch mains
Crank is a Bryant 4.150 stroke 3 inch main purchased new never hurt
Several spare rod and main bearing sets
Cam is a double swap
Heads are Brad 6 with Ried exhaust and Manton intake rockers And Manton stands
Lifters are Cam FX 1 inch dia. Serviced by Cam FX two runs ago
Valves are Victory with built in lash caps
Valve springs are PAC
Push rods are Manton with two spare each intake and exhaust
Mag is a Pro Mag 44 updated by System One to 63 amps
MSD Power Grid ignition timing controller
Dave Leahy fuel management system
Racepak SC1000 data logger with fuel pressure, oil pressure, transmission pressure, Wheel speed, timing