Results 1 to 2 of 2

Thread: Mid motor plate extension kit.

  1. #1

    Mid motor plate extension kit.

    Just installed on my car bbc/tube chassis and my problem is with the pilot spacer for 1/4 plate. The id of the spacer is 1.4" and the od of the pilot on the converter is 1.703". TCI tech told me the pilot on the conv. should fit inside the pilot bushing extension. If so then the conv. would only be bushed and not spaced.So do I not use this or use crank spacers that go on between the flexplate and crank end . ?The kit I have is TCI 745504.The end of the pilot spacer is even with the end of the crank so the converter will be next to impossible to line up.

  2. #2
    Senior Member DYNO OPERATOR
    Join Date
    Aug 2005
    Location
    Rifle Colorado
    Posts
    585
    My understanding is that TCI race converters have a sleeve on the pilot end. The extension replaces that sleeve with a longer one, so you'll have to remove the existing one......if you don't have a TCI converter, you may have to go a different route.....

    Johnny


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Email us - Support@RacingJunk.com
Call us - 866.326.9227
Copyright © 2005-2016 RacingJunk.com All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the RacingJunk.com
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy