Results 1 to 3 of 3

Thread: S 10 fiberglass rear roll pan with wheelie bar cut out

  1. #1
    Senior Member DYNO OPERATOR
    Join Date
    Jan 2004
    Location
    central Illinois
    Posts
    459

    S 10 fiberglass rear roll pan with wheelie bar cut out

    Looking for a rear roll pan for a 1997 S 10 that is fiberglass and already has the cut out for wheelie bars in it.

    Don't have wheelie bars, but the truck sets so low have to roll up on boards to put a jack underneath it in the rear.

    Anyone know who sells them?

  2. #2
    Senior Member RACING JUNKIE
    Join Date
    Jan 2006
    Location
    La.
    Posts
    2,890
    Mark have you looked at the S10/Sonoma stepside rear bumper cover. it's eith fiberglass or rubber, i have a Sonoma shortbed stepside, prostreet truck in process. You could cut out the lic plate section and move it out to fit the regular bed i think. I don't remember if it fiberglass or rubber, but i could a pic and post it or send it to PM to see if it would soluve your problem.

    Zip.

  3. #3
    Senior Member DYNO OPERATOR
    Join Date
    Jan 2004
    Location
    central Illinois
    Posts
    459
    Thanks Zip, I will look that combo over.


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Email us - Support@RacingJunk.com
Call us - 866.326.9227
Copyright © 2005-2016 RacingJunk.com All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the RacingJunk.com
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy