How much H/P will a corp. 14 bolt hold.
#5
Originally Posted by sethz79
PM? we're 4-wheelers, running older stuff but it's big stuff.
A Samurai or Toyota with a 4 cylinder and 33's and you'll probably never break 'em.
A full size truck with 44 boggers with a 600+hp hill climbing you're gonna break both front and back often.
Need a lot more info to be able to answer your question.
#7
Originally Posted by sethz79
I'll be running a 496 stroker moter around 600 h/p with 40 inch pitbulls.
WHAT ARE YOU DOING WITH THE TRUCK?
ARE YOU MUD RACING?
ARE YOU HILL CLIMBING?
ARE YOU HILL N HOLE RACING?
ARE YOU FAST TRACK (TOP GROUND AS SOME CALL IT) RACING?
ARE YOU JUST BUILDING A TRUCK FOR RIDING AROUND TOWN?
If you ride up and down the highway, you will never have a problem. :wink:
HELP ME HELP YOU! LOL
#10
600hp is pretty stout for a driver, but you should be fine with the 14 bolt with no more than you plan to do.
I ran 42's and 44's on my 1/2 ton stuff for years and would break a front axle every now and then. (And I've always been pretty hard on 4x4's :wink: )
I switched to a dana 70 rear and dana 60 front and it added a bunch of weight to my truck. Not to mention had to get different wheels too.
I ran 42's and 44's on my 1/2 ton stuff for years and would break a front axle every now and then. (And I've always been pretty hard on 4x4's :wink: )
I switched to a dana 70 rear and dana 60 front and it added a bunch of weight to my truck. Not to mention had to get different wheels too.