Results 1 to 2 of 2

Thread: Found very low voltage on my Trans Brake Switch up

  1. #1

    Found very low voltage on my Trans Brake Switch up

    I was wiring up my practice tree to my Biondo TB switch & it wouldnt work on the tree, but on any other switch I tested it worked.
    I then took a voltage meter when it was hot normal 12 volts when open it was reading between .09 & .06 volts

    I disconected the msd 2 step to see if any difference & still showed the same small voltage.
    is this switch bad?

  2. #2
    biondo says its ok, you must disconect any box/transbrake to use the tree any voltage from the tree will try to power stuff.
    Dont use your tree with 12 pover applied to switch!


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Email us - Support@RacingJunk.com
Call us - 866.326.9227
Copyright © 2005-2016 RacingJunk.com All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the RacingJunk.com
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy