Results 1 to 3 of 3

Thread: Powerglide pump

  1. #1
    Senior Member DYNO OPERATOR
    Join Date
    Aug 2007
    Location
    Lost Creek, WV
    Posts
    533

    Powerglide pump

    Once a powerglide pump has been made to accept a turbo spline input shaft, can a powerglide spline input shaft be put back into the pump?

    TS1955

  2. #2
    You can put the glide shaft right back in with no other changes. the diference is the busging that goes in the end of the stator shaft to support the turbo shaft. You can remove the bushing, but it is not nesecary because the glide shaft is smaller diamater and will not toutch the bushing.
    Rob

  3. #3
    Senior Member DYNO OPERATOR
    Join Date
    Aug 2007
    Location
    Lost Creek, WV
    Posts
    533
    Quote Originally Posted by Robstclair
    You can put the glide shaft right back in with no other changes. the diference is the busging that goes in the end of the stator shaft to support the turbo shaft. You can remove the bushing, but it is not nesecary because the glide shaft is smaller diamater and will not toutch the bushing.
    Rob
    Thanks Rob. I was pretty sure about that but wanted to confirm it.

    TS1955


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Email us - Support@RacingJunk.com
Call us - 866.326.9227
Copyright © 2005-2016 RacingJunk.com All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the RacingJunk.com
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy