Results 1 to 5 of 5

Thread: ford nine in.

  1. #1

    ford nine in.

    Did a gear pack change with a complete oil drain, have put in three quarts and has not flowed out filler hole. Keep going or hold off???? Thanks for the reply

  2. #2
    Senior Member RACING JUNKIE TheYellaBrick's Avatar
    Join Date
    Mar 2008
    Location
    Emmett, Idaho
    Posts
    7,334
    I know this sounds pretty basic but, is the rear axle housing LEVEL? If one side is lower, it'll fill up the entire housing tube on the low side.
    TRUTH is HATE
    to those who
    HATE TRUTH

    God Bless our folks in uniform
    "We the People, have your backs"
    http://www.racingjunk.com/profile/279898

  3. #3
    Moderator RACING JUNKIE Harbone's Avatar
    Join Date
    Aug 2007
    Posts
    3,918
    Blog Entries
    1
    everything I have says 2 to 2 1/2 quarts. Do you have a stock 9", are you filling in the stock hole or has someone welded a filler on the top?
    Chris

    As close to "Normal" as I can get...

  4. #4

    ford 9.in

    1976 ford 9 in. mosier center with4.56 bracket car. filler near top on side. Fluid is even w hole and will leave as is.

  5. #5
    Senior Member RACING JUNKIE
    Join Date
    Dec 2008
    Location
    Sugar Hill, GA
    Posts
    1,365
    Wrong hole to check level.
    Dave
    http://www.racingjunk.com/profile/343797
    "All that is necessary for the triump of evil is for good men to do nothing" Edmund Burke


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Email us - Support@RacingJunk.com
Call us - 866.326.9227
Copyright © 2005-2016 RacingJunk.com All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the RacingJunk.com
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy