Results 1 to 2 of 2

Thread: slicks mounting and tubes

  1. #1
    Junior Member APPRENTICE
    Join Date
    Feb 2009
    Posts
    19

    slicks mounting and tubes

    After running over an old bearing i popped my 31x14xr15 slick, luckily my dad had another pair i got off him. My old slicks were running inner tubes and most tire places won't touch anything with a tube.

    My question should i mount them without the tubes i have just steelie rims that are dished for my car they were done a few years ago but i just have duck tape over the two seems where it was dished will it hold air and i run tire screws also. I havent screwed around with tires alot i see alot of people say you dont need them (inner tubes) and also if i take out the tube i'll need the large valve stem correct? any inout would be great

  2. #2
    Senior Member RACING JUNKIE TheRabbit's Avatar
    Join Date
    Jan 2007
    Location
    Augusta, Ga.
    Posts
    2,295
    There are already several threads about tubes.


    http://forums.racingjunk.com/viewtop...ighlight=tubes


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Email us - Support@RacingJunk.com
Call us - 866.326.9227
Copyright © 2005-2016 RacingJunk.com All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the RacingJunk.com
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy