Results 1 to 1 of 1

Thread: MW Accubond driveshaft on a street/strip application?

  1. #1
    Member MASTER JOURNEYMAN
    Join Date
    Oct 2008
    Location
    Desoto, MO
    Posts
    37

    MW Accubond driveshaft on a street/strip application?

    I was looking at using a 4" Bonded MMC Mark Williams drivehshaft on my next truck build, this will be a street/strip build, is there any reason that I should not use the bonded shafts? Fwiw, this is on a small truck >3000lbs, and shold be around 53.5" center/center. Thanks guys.

  2. Racing Junk


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Email us - Support@RacingJunk.com
Call us - 866.326.9227
Copyright © 2005-2016 RacingJunk.com All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the RacingJunk.com
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy