Results 1 to 2 of 2

Thread: head gasket

  1. #1
    Junior Member SHOW GUEST
    Join Date
    Oct 2009
    Location
    greenville nc
    Posts
    9

    head gasket

    i am installing a set of Pro Comp PC5213 CHEVY SBC 400 ULTRA HIGH PERFORMANCE STAINLESS MULTI-LAYER HEAD GASKETS Three layers of pure 304 stainless steel
    Outer layers embossed and coated on both sides with Viton a state of the art flourelastomer rubber based material
    but not shure what side should face up ,raised or concaved , i put raised up but had to knotch for oil stick always installed raised side up but hope this was rite and will work they were knotched for oil stick flipped this side down STEEL gaskets raised side up i alway thought

  2. #2
    Senior Member SENIOR BUILDER
    Join Date
    Nov 2008
    Location
    Phoenix AZ
    Posts
    116
    I haven't seen the pro comp gaskets, but I would assume they are similar to the FelPro and Cometics. With Cometic and FelPro there is no specific orientation. Either side can go up.


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Email us - Support@RacingJunk.com
Call us - 866.326.9227
Copyright © 2005-2016 RacingJunk.com All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the RacingJunk.com
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy